Connecting The Appliance To The Power Supply; Electrical Connections - Zanussi ZBG26542XA User Manual

INSTALLATION

CONNECTING THE APPLIANCE TO THE POWER SUPPLY

• The electrical outlet should be readily accessible so that the unit can be
unplugged easily in an emergency. Or it should be possible to isolate the
oven from the supply by incorporating a switch in the fixed wiring in
accordance with the wiring rules.
• The socket should not be positioned behind the cupboard.
• The best position is above the cupboard, see (A).
• Connect the appliance to a single phase 230 - 240 V V/50 Hz alternating current via
a correctly installed earth socket.
• If the appliance is to be operated in a non-European country, the supply
voltage, current type and frequency of the appliance indicated on the rating
plate must correspond with the specification of your power supply. The rating
plate can be found on the inside face of the control panel.
• The power supply cord may only be replaced by an electrician.
• Before installing, tie a piece of string to the power supply cord to facilitate connection to point (A) when the appliance is being
installed.
• When inserting the appliance into the high-sided cupboard, DO NOT crush the power supply cord.
• Do not immerse the power supply cord or plug in water or any other liquid.

ELECTRICAL CONNECTIONS

WARNING:
THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should this
safety measure not be observed.
• If the plug that is fitted to your appliance is not suitable for your socket outlet, it must
be cut off and the appropriate plug fitted.
• Remove the fuse from the cut off plug. The cut off plug should then be disposed of
to prevent the hazard of shocks in case it should be plugged into a 13 Amp socket
in another part of your home.
Important:
The wires in the mains lead are coloured in accordance with the following code:
GREEN AND YELLOW
BLUE
BROWN
If you fit your own plug, the colours of the wires in the mains lead of your appliance may
not correspond with the markings identifying the terminals in your plug, proceed as follows:
• Connect the green and yellow (earth) wire to the terminal in the plug which is
marked with the letter "E" or the earth symbol (
• Connect the blue (neutral) wire to the terminal in the plug which is marked with the
letter "N" or coloured black.
• Connect the brown (live) wire to the terminal in the plug which is marked with the
letter "L" or coloured red.
EARTH
NEUTRAL
LIVE
) or coloured green and yellow.
30
(A)
GREEN & YELLOW
13 AMP FUSE
BROWN
BLUE
CORD CLAMP