Physical Interface - Rear View - Cisco Video Switch User Manual

Video Switch
Contents

Physical Interface - Rear View

D14794.02 Video Switch User Guide, October 2012
© 2011-2012 Cisco Systems, Inc. All rights reserved.
Introduction
12 volt power supply.
The power supply is the same as used for the PrecisionHD camera, Edge MXP and Set Top endpoints.
2 × Component (Y-Pr-Pb) video for Supporting 3 party cameras, like the Sony EVI-HD1 or BRCH700
cameras.
4 × DVI-D Video inputs from Precision HD cameras – PrecisionHD camera HDMI output to DVI-D on the
Video Switch.
3 × Data ports:
• Data port 1 is for controlling the PrecisionHD cameras from Cisco and 3 party cameras.
• Data port 2 is for controlling SD type cameras like the TANDBERG WAVE II or Sony EVI cameras.
• Data port 3 is for external control systems to control the Video Switch.
1 × TANDBERG High Speed Interface (THSI) Output - Data port 2 from 6000 MXP or Camera port from
3000 MXP to the THSI on the Video Switch.
1 × HDMI video output – Not in use
The Video Switch The Video Switch Safety instructions and approvals
7
User guide
Contact us
www.cisco.com