Garmin zumo 500 Owner's Manual page 11

G S
ettinG tarted
A) To install the U-bolt and handlebar
base:
1. Place the U-bolt around the handlebar,
and thread the ends through the handlebar
base.
2. Tighten the nuts to secure the base. Do
not overtighten.
notE: The recommended torque
is 50in-lb. Do not exceed maximum
torque of 80in-lb.
B) To install the handlebar base to the clutch/brake clamp bracket:
notE: Both 1/4" standard
and M6 bolts are included.
Match the size of the
factory bolts on your
clutch/brake clamp bracket.
1. Remove the two factory bolts
on your clutch/brake clamp
bracket.
2. Thread the new bolts through
the handlebar base, spacers,
and clamp bracket.
3. Tighten the bolts to secure the base.

Autogood products internet store http://130.com.ua
Handlebar
base
zūmo 500/550 Owner's Manual
Handlebar
base
U-bolt
Handlebar
Clutch/brake
clamp bracket
Spacers