Thermal Considerations; Ac Power Considerations; Ac Power Distribution - Mackie SRM450v2 User Manual

THERMAL CONSIDERATIONS

The amplifiers inside the SRM450vs are
convection cooled by a large heatsink.
For efficient cooling, it is important to
allow at least six inches of free space
behind the SRM450v.
If you use the SRM450v on its side for
stage monitor applications, we highly
recommended that you engage the rear
panel LOW CUT switch. This will allow
more power for useful monitor frequen-
cies, while reducing the possibility of
overheating.
If the ambient temperature in the room is high, though
ACTIVE SOUND REINFORCEMENT SYSTEM
highly unlikely, it could cause the amplifiers to overheat.
In this case, you should try aiming a fan at the heatsink to
increase the air flow through the fins.
During a performance, don't have it cranked so high that
the rear panel PEAK LED is blinking frequently or lighting
continuously. You should turn down the LEVEL control a
notch or two to avoid overheating the amplifiers or your
neighbors.
If the amplifiers do overheat, a built-in thermal switch
will activate, placing the amplifiers into standby. When the
amplifiers have cooled down to a safe operating tempera-
ture, the thermal switch will reset and the SRM450v will
resume normal operation.
HEATSINK
THERMAL
THERMAL
ON
OFF
TIMED TURNOFF
1
LOW CUT
PEAK SIGNAL PRESENT
NORMAL
(+4dBu)
POWER
LINE
100Hz 12k/AIR 75Hz
O O +40dB
ON CONTOUR LOW CUT
+3dB
LEVEL
O
THRU INPUT
PARALLEL

AC POWER CONSIDERATIONS

Be sure the SRM450v is plugged into an outlet that is
able to supply the correct voltage specified for your model.
If the voltage should drop below 97% of the specified line
voltage, the built-in amplifiers will no longer be able to
supply rated power. (They will continue to operate down
to 75% of the rated line voltage, but won't reach full power,
resulting in lower headroom).
Under maximum SPL conditions, where musical peaks
are clipping, the SRM450v 10V model draws .5 amps on
average (1. amps for the 40V model). Under normal con-
ditions, the current draw is below 1 amp.
We recommend that a stiff (robust) supply of AC power
be used because the amplifiers place high current demands
on the AC line. The more power that is available on the line,
the louder the speakers will play and the more peak output
power will be available for cleaner, punchier bass. A sus-
pected problem of "poor bass performance" is often caused
by a weak AC supply to the amplifiers.

AC Power Distribution

A 40 VAC center-tapped service entrance transformer
serves the majority of AC outlets encountered in homes and
clubs (in the U.S.). This provides two phases of AC power
on either side of the center tap, at 10V each.
If lighting is used in a show, it is preferable to power
the lights from one leg of the service, and power the audio
equipment from the other leg. This will help minimize
noise from the lights coupling into the audio (particularly if
SCRs, or light-dimmer switches, are used).
Wherever possible, connect all of your equipment to the
same electrical circuit. This will help reduce the possibility
of a ground loop problem causing an annoying hum in your
speakers.
Low power components such as tape decks, mixers, ef-
fects processors and CD players should be connected to the
same outlet as the SRM450vs. Use fused power strips as
shown in the diagram on the next page. Make sure that the
total current draw of your components does not exceed the
capability of the outlets and power strips.
HIGH VOLTAGE POWER LINE
PEAK
PRIMARY
WINDING
MIC
240V CENTER-TAPPED SECONDARY
120V
120V
EARTH
TRANSFORMER
GROUND
(NEUTRAL)
SECONDARY
240V
WINDING