Client Setup - D-Link DCS-6112V User Manual

Configuration

Client Setup

Clicking the Client Settings button will bring you to the following screen which
allows you to configure the basic protocol options for you camera.
H.264/MPEG4 Media Options
Video and Audio can be viewed at the same time or seperately.
H.264/MPEG4 Protocol Options
For additional information about streaming options please see page 41.
UDP Unicast: Stream to a single computer.
UDP Multicast: Stream to multiple computers using multicast
streaming.
TCP: Provides higher quality video streaming than UDP and provides error
correction. However, transmission speed will be reduced.
HTTP: Offers the highest image and video quality. However, packet loss will
diminish image quality when bandwidth becomes restricted. If the network is protected by a firewall and it opens only HTTP port (80),
HTTP protocol must be selected. In this mode, audio is disabled and only video can be viewed. UDP connections will not be available
to remote users if all four ports have not been forwarded (as shown on page 46). Only the HTTP port must be forwarded for remote
users to make an HTTP connection (video only).
MP4 Saving Options
Folder: Select the folder where you would like the MP4 file saved on your desktop computer.
File name prefix: Enter a file name prefix for the MP4 files.
Add date and time suffix to file name: Select this checkbox if you would like the date and time to be added to the end of each
filename.
Local Streaming Buffer Time
Enter the buffer time in milliseconds. The buffer will cause a slight delay between live activity and the video of the live stream but may
increase the quality of video.
D-Link DCS-6112V /6113V User Manual 27