Advanced programmings and registrations
Programming functions of departments and PLUs individually
Programming functions of departments individually
This part explains programming methods of each function of departments indi-
vidually.
Step
1
Turn the Mode switch to PGM position and select [System
Setting] then press
F
2
Enter
3
and press
programming mode.
3
Referring the following table, enter two-digit set code you
wish to program followed by two 6s. The "66" is the identifi-
cation code for individual programming of departments and
PLUs. Then press
o
4
You can skip this step if you program in departments 01
through 25. If you wish to program in departments 26
through 50, press <Dept. no./Dept. shift> key.
5
Referring the following table, enter program code and press
the department key in which you wish to set.
6
If you wish to set the same function in another department,
press the corresponding dept. key.
7
Repeat steps 4 and 5 to set another function in another
department.
8
Press
key to complete the program.
o
key.
key to set the register in the
o
key.
Operation
>▪▪▪▪▪>F
3o
BB66o
(set code)
<Dept. no./Dept. shift>
123#
This example is for linking dept. 03 to item
group 123 assuming set code 11 has been
entered in step 3 and <Dept. no./Dept. shift>
key is not pressed in step 4.
$
This example is for setting the same linking
group in dept. 04.
o
E-99