Table of Contents
Advertisement
EN | 16
all the configuration settings. The level user allows you to establish and
terminate connections but does not allow access to the configuration.
– The Unit access section controls the access to VIDOS Monitor Wall from
VIDOS. Here, you can set which protocol and which HTTP port VIDOS will
use to communicate with VIDOS Monitor Wall.
If VIDOS Monitor Wall is password protected, you can save the password for
access by VIDOS here.
The General tab
– Under Date/Time, this tab shows the time setting for the PC on which
VIDOS Monitor Wall is running.
You cannot make any changes to the setting here. If you want to use a
different time setting, you must make the changes directly on the relevant PC.
The Decoder tab
– Under Monitor, you can assign the monitor names. The names are displayed
in the VIDOS resource tree next to the hardware monitor icons.
The Alarm tab
– These settings are very important if senders in the system are protected with
a user password. Under Alarm connections receiver you can make 10
entries with an IP address and associated user password, so that the
connection can be established in case of an alarm.
However, under number 10 you can also leave the IP address setting as
0.0.0.0 and assign a user password. VIDOS Monitor Wall then has access to
all devices with this user password. This allows you to integrate more than 10
password-protected senders into the system.
Exiting VIDOS Monitor Wall
Press the Esc key to exit VIDOS Monitor Wall.
This terminates the camera connections, which will need to be re-established
using VIDOS when VIDOS Monitor Wall is restarted.
Installation and Setup
Installation and Operating Manual | VIDOS Monitor Wall
Bosch Security Systems | 2005-09 | V1.0
I
Advertisement
Table of Contents
