D-Link DSL-2750U User Manual page 52

Appendix A – Troubleshooting
IP Filtering - Outgoing
This window allows you to create a filter rule of Outgoing.
Click change default policy to change the mode of policy.
Now default policy is BLOCK, it means all outgoing IP traffic from LAN is
blocked, but some IP traffic can be accepted by setting up filters.
If you are setting up the outgoing IP filtering, click the Add button.
Now default policy is ACCEPT, it means all outgoing IP traffic from LAN is
allowed, but some IP traffic can be Blocked by setting up filters.
If you are setting up the outgoing IP filtering, click the Add button.
Enter the information in the section. Explanations of parameters are
described below. Click the Apply / Save button to add the entry in the
Active Outbound IP Filtering table.
D-Link DSL-2750U User Manual 52