Incorrect Time And/Or Date; Drives Are Reported As "Dead; Added Drive Reported Defective; Error Messages On The Screen - Fujitsu PRIMERGY Econel 100 Operating Manual

Troubleshooting and Tips
7.7

Incorrect Time and/or Date

Ê Set the time and date in the operating system or in the BIOS Setup under the
Main menu with System Time and System Date respectively.
I
If the time and date are still wrong after the server has been switched off
and back on again, change the lithium battery (for a description see the
D2179 system board Technical Manual), or contact our customer service
team.
7.8

Drives Are Reported as "Dead"

RAID controller configuration incorrect
Ê Check and correct the settings for the drives with the RAID controller utility.
Further information is provided in the manual on the RAID controller.
7.9

Added Drive Reported Defective

This error message may occur when the server has a RAID controller:
RAID controller is not configured for this hard disk drive
Ê Reconfigure the RAID controller for the drive with the corresponding utility.
Information is contained in the documentation on the RAID controller.
If the hard disk drive continues to be shown as defective, then replace it (see
"PRIMERGY Econel 100 Server System Options Guide").
7.10

Error Messages on the Screen

The meanings of the error messages are explained in the "BIOS Setup" manual
and in the documentation for the relevant components and programs on the
PRIMERGY ServerBooks CD.
Econel 100
Operating Manual
Incorrect Time and/or Date
45