Energy Star - Fujitsu PRIMERGY TX100 S3 Operating Manual

Important information
4.2

ENERGY STAR

In typical configurations the PRIMERGY TX100 S3 satisfies the
stringent requirements of the Ecolabel Energy Star for
Computers Version 5.0. These requirements ensure energy
savings and help to save money and reduce greenhouse gas
emissions when computers are being used and performing a
range of tasks, as well as when they are turned off or into a low
power mode. For example, the power consumption of the
PRIMERGY TX100 S3 in the operation mode "idle" is less than
65 W.
Products that have been certified compliant with ENERGY STAR
and identified as such are in full compliance with the specification
at shipping. Note that energy consumption can be affected by
software that is installed or any changes that are made to the
BIOS or energy options subsequently. In such cases, the
properties guaranteed by ENERGY STAR can no longer be
assured.
Detailed information concerning the requirements for the "Energy
Star" eco-label, as well as products that satisfy these
requirements, can be found on the Internet at
http://www.energystar.gov/ .
After you have installed your OS you can configure the energy
saving settings by yourself (amongst others switch off the
monitor ≤ 15 minutes). How you have to configure these energy
saving settings is described in the documentation supplied with
the OS.
The "ServerView Operations Manager" user guide contains
instructions for reading out measurement values, including those
relating to current energy consumption and air temperatures.
Either the Performance Monitor or the Task Manager can be
used to read out CPU utilization levels.
The system has a hibernate mode (S4 mode) from which it can be woken up via
WOL (Wake-up On LAN). In order to use this feature, however, the S4 mode
must be activated/enabled in the corresponding operating system installed.
The following description is an example and can only serve as a guide for other
operating systems.
36 Operating Manual
TX100 S3