Surface; Ounting The; Housing - GE DR-1200 User Manual

Rugged Dome Installation Manual
2.1 S
URFACE
To surface-mount the housing, see Figure 8 and perform the following.
Mounting

surface

Anchors
Outer plate
Inner plate
M4x20 truss-head
tapping screws
M4x12 pan-head
double-washer
screws (3)
(through housing
base)
Figure 8. Surface-mounting the housing
Note: Feed the cables through the mounting surface, plates, and housing at the
appropriate time depending on whether you are using the flying lead and whether the cable
is external or internal to the mounting surface.
To prepare the mounting surface perform the following.
1) Position the outer plate on the mounting surface at the installation
location.
2) Trace the position of the mounting holes.
3) If you are using the back cable entry, trace its outline.
4) Drill the outlined mounting holes.
1038346B / February 2003
-M

OUNTING THE

(3)
H
OUSING
Mounting the Unit
9