Door Reversal; Reversing The Door - Electrolux Wine cooler Use & Care Manual

Reversing the Door

This model comes equipped with a RH-swing door.
To convert the unit to a LH-swing door (as shown
in the Use & Care Guide), certain components
must be obtained before beginning the conversion.
These components are available from your local
dealer or by calling Electrolux.
Order Part Number: 5303418377
To reverse the door:
1 Disconnect power to the wine cooler.
2 Remove toe grille by removing two screws.
Remove
2 Screws
Remove
Toe Grille
3 Disconnect door harness from connector
bracket behind lower front panel. Pull
harness from behind lower front panel so it is
hanging below the door.
Bracket
Disconnect
Connector
From Bracket
Pull Harness Out Below Door

Door Reversal

4 Remove upper right-hand (RH) hinge
bracket by loosening four screws. Be careful
to support the door while loosening and
removing the upper hinge bracket.
Remove
Hinge Cover
(Some Models)
Remove 4
Screws and
Hinge Bracket
5 Lift the door off of the lower RH hinge
bracket. Turn the door upside down and place
on a soft, non-abrasive surface.
Door
Lift Door Off Lower
Door Hinge
9
Support
Door
During
Removal
Hinge