Needle Threading (C) (D) - Husqvarna Viking Huskylock 936 User Manual

3-3. Needle threading ( C ) ( D )
1. Raise the presser foot.
2. Raise the needle to its highest position by
turning the handwheel toward you.
3. Pull thread from spool through guide
Note: Make sure the thread snaps into the slot
➁
of guide and between the thread ten-
➂
sion discs .
4. Pull the thread through guides
the right needle and through guides
for the left needle.
Note: Make sure that right needle thread (D)
passes to the right of the guide
left needle thread (C) to the left.
5. Slide the thread into the ditch of needle
threader.
6. Hold the needle threader to the needle with
the mark on top and bottom side. Slide
it along the needle to the needle eye. The
thread will loop through the eye of the needle.
7. Pull the thread through the needle eye
with tweezers leaving about 10 cm (4") of
thread tail.
➀
.
④ ➄ ➅
, , for
➄ ➅
,
➄
and
➆
,
—18—
C D A
1
2
3
5
6
7
B
4