Wired Connection - Philips 42PFL5008G User Manual

Connect
T V
Router
You can connect this TV to your home
network through a wired or wireless
connection.
•
For a wired connection, see Connect
your TV > Connect to a network and
the Internet > Wired connection
(Page 59).
T V
Router
•
For a wireless connection, see Connect
your TV > Connect to a network and
the Internet > Wi-Fi integrated (Page
59).

Wired connection

1. Switch on the router and switch on its
DHCP setting.
2. Connect the router with an Ethernet
cable to the TV.
3. Press , then select [Setup].
4. Select [Connect to network], then press
OK.
5. Follow the onscreen instructions to install
the network.
6. Wait for the TV to find the network
connection.
7. If you are prompted, agree to the End
User License Agreement.
Internet
PC
Internet
PC
Wi-Fi integrated
This section is only applicable for Wi-Fi
integrated TVs.
You can connect your TV to your home
network wirelessly.
Note:
•
The wireless network operates in the
same 2.4 GHz frequency spectrum as
common household devices, such as
Dect phones, microwave ovens or
Bluetooth devices, which can cause
Wi-Fi interference. Move these devices
away from the TV.
•
For optimum Wi-Fi performance, place
the TV at a distance of less than 10 m
from the wireless router. Avoid
obstructions such as concrete walls
between the router and the TV.
•
Reception quality depends on the
location of the wireless router, and the
local Internet service provider.
•
To reduce network traffic, switch off
unused network equipment in the
home network.
•
While you play video over your
wireless home network, we
recommend that you use an IEEE
802.11 N router. The connection speed
may differ according to the operating
environment of your wireless home
network.
Start wireless setup
1. Switch on your wireless network router.
2. Press on the TV remote control.
3. Select [Setup] > [Connect to network],
then press OK.
4. Follow the onscreen instructions.
WPS - Wi-Fi Protected Setup
1. If your router supports Wi-Fi Protected
Setup (WPS), press the WPS button on the
router.
2. After 2 minutes, select [WPS] on the TV,
then press OK.
The TV connects to your network. This
takes about 2 minutes.
EN 59