Advertisement
TM
PSW26SGR – GE Profile Arctica
with Dispenser
Hinge Screws
4.
3.
Wire Harness
Water Line Coupler
Specification Revised 7/04
210398
ENERGY STAR
25.5 Cu. Ft. Stainless-Wrapped Side-By-Side Refrigerator
®
®
1.
Toekick Screw
To Remove Top Cap and Doors on PSW26SGR
Step 1: Locate and remove two Phillips head screws on the top of
the refrigerator. Remove two screws, one on each side at
the rear of the top cap. Lift off and remove top cap.
Step 2: Open both doors. Remove one screw on each side of the
toekick. Pull forward to remove toekick.
Step 3: On the freezer door, disconnect water line coupler by
pushing against the collar on the left side. Disconnect
wire harness.
Step 4: Use a Torx T-20 screwdriver to remove 2 screws holding the
top hinge. Carefully remove hinge while supporting door.
Lift door up and off bottom hinge. Remove fresh food door
in the same manner. Note: Do not remove bottom hinges!
Door alignment will be difficult if bottom hinges
are removed.
Step 5: Place refrigerator onto a hand truck, upright and against
one side. Move refrigerator to the installation location.
Reinstall Doors, Top Cap
Step 6: Carefully lower doors onto bottom hinges. Be sure to route
the tubing and electrical connector through the bottom
hinge. Reinstall top hinges.
Step 7: Place cap over the top of the refrigerator. Reinstall the
original screws in the top and back of the cap.
Step 8: Reconnect the wiring harness and waterline.
2.
Total volume and shelf
area are calculated by
the Association of Home
Appliance Manufacturers'
standards.
Listed by
Underwriters
R
Laboratories
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
For answers to your Monogram,
®
GE Profile
GE
appliance questions, visit our website at
®
GEAppliances.com or call
GE Answer Center
service, 800.626.2000.
®
R
™
or
Advertisement
