Table of Contents
Advertisement
NetVanta 1600 Series Hardware Installation Guide
Connecting the NetVanta 1131 and the NetVanta Switch
Follow these instructions to connect your NetVanta 1131 RPS/EPS to your NetVanta switch
Instructions for Connecting the NetVanta 1131 to the NetVanta Switch
Step
1
Ensure that all power sources have been removed from the NetVanta 1131 and the NetVanta
switch(es) to be connected.
2
With a Phillips head screwdriver, remove the cover plates from both the NetVanta 1131
RPS/EPS receptacles and the NetVanta switch's RPS/EPS receptacles on the rear panels of
the units.
Important! Do not remove the cover plates from the RPS/EPS receptacles unless you plan to
use them.
3
Insert one end of the RPS cable (P/N 1700532F1) into a receptacle labeled RPS1, RPS2, or
RPS3 located on the rear panel of the NetVanta 1131. Press the connector until the pins are
fully inserted and the base of the connector is flush with the unit.
Important! Do not use excessive force. If the connector does not insert easily, check to ensure
you are inserting the correct connector into the unit.
4
Insert the connector on the other end of the RPS cable into the receptacle labeled RPS located
on the rear panel of the NetVanta switch. Press the connector until the pins are fully inserted
and the base of the connector is flush with the unit.
5
If you plan to use the NetVanta 1131 as an EPS, repeat Steps 1 through 4 using the EPS cable
(P/N 1700533F1) and the receptacles labeled EPS located on the rear panels of the NetVanta
1131 and the NetVanta switch and an EPS cable.
6
To remove an RPS or EPS cable from the unit, pinch the sides of the connector and pull gently
to release it from the receptacle.
7
Proceed to
Powering the NetVanta 1131 and the NetVanta Switch on page
61700568F1-34D
Action
Copyright © 2013 ADTRAN, Inc.
NetVanta 1131 RPS/EPS
.
42.
41
Hide quick links:
Advertisement
Table of Contents
