Crate CPB150 User Manual

Crate CPB150 User Manual

150 watt stereo guitar amplifier

Advertisement

CPB150
150 Watt Stereo Guitar Amplifier
User's Guide

Advertisement

Table of Contents
loading

Summary of Contents for Crate CPB150

  • Page 1 CPB150 150 Watt Stereo Guitar Amplifier User’s Guide...
  • Page 2: Table Of Contents

    CPB150 PowerBlock 150 Watt Stereo Guitar Amplifier TABLE OF CONTENTS: Introduction ........3 The Front Panel .
  • Page 3: Introduction

    Crate PowerBlock! (In order to get the most from your new PowerBlock, please read this user’s guide prior to its use.) The Crate PowerBlock amplifier can drive up to four of our GT112SL cabinets, in stereo, or drive a single Celestion speaker-loaded GT112SL to the hilt in mono mode.
  • Page 4: The Front Panel

    CPB150 PowerBlock 150 Watt Stereo Guitar Amplifier The Front Panel: 1. INPUT: Use this 1/4” jack to connect your 5. LOW: Use this control to adjust the low fre- instrument to the amplifier by means of a quency output of the amplifier.
  • Page 5: The Rear Panel

    CPB150 PowerBlock 150 Watt Stereo Guitar Amplifier The Rear Panel: 9. SPEAKER OUTPUTS: Use these jacks to 13. CD INPUT: Use these RCA jacks to con- connect the amplifier to your speaker cabi- nect the outputs of a CD (or MP3) player to the nets.
  • Page 6: Using The Effects Loop Jack

    CPB150 PowerBlock 150 Watt Stereo Guitar Amplifier Using the Effects Loop Jack: The Effects Loop Snd/Rtn jack allows for virtually noise free connection of external effects. You will need a stereo-to-dual-mono 1/4” adapter as described in the illustrations below. This T/R/S jack is wired as follows: tip = return, ring = send, sleeve = ground.
  • Page 7: System Block Diagram

    CPB150 PowerBlock 150 Watt Stereo Guitar Amplifier System Block Diagram: INPUT PREAMP LINE LEVEL – GAIN HIGH MID LOW LINE OUT LEVEL EFFECTS LOOP SND/RTN SPEAKER SIM LEFT LINE IN LEFT/MONO INPUT SPEAKER SIM LEFT SPEAKER RIGHT OUTPUTS LEFT RIGHT...
  • Page 8: Specifications

    Weight 4.6 lbs. The CPB150 is housed in an anodized aluminum chassis: occasionally wipe it clean with a lint-free cloth. Never spray cleaning agents onto the unit. Avoid abrasive cleansers which would damage the finish. Crate continually develops new products, as well as improves existing ones. For this reason, the specifications and information in this manual are subject to change without notice.

Table of Contents