Pyle PDT35 Operating Instructions

OPERATING INSTRUCTIONS
FULL-AUTO DIGITAL ELECTRICAL TESTER
PDT35
Safety Information

Never use the tester if it or its test leads appear damaged.

Never apply more than 600V DC or 600V AC rms. Between any terminal
and earth ground

When using the probes, keep your fingers behind the finger guards on
the probes.

Turn off power to the circuit under test before cutting, unsoldering, or
breaking the circuit. Small amounts of current can be dangerous.

Use caution when working with voltages above 60V DC or 30V AC rms.
Such voltages pose a shock hazard.
Automatic Operation
The tester automatically turns on when you short the two test probes or place
the probes across a complete circuit.
When turned on, the tester powers up in continuity mode. If a DC or AC
voltage greater than about 4.0V is present across the inputs, the tester
switches to DC or AC voltage mode.
The tester automatically shuts down after approx. 4 minutes of inactivity.
Continuity testing
Turn off circuit power before testing.
Beeper indicates shorts lasting 1 ms or longer.
SHORT
10K OPEN
Measuring Voltage
Refer to Automatic Selection
DC Voltage (Volts DC>4.0V)
600V DC maximum
12V DC
Specifications
Function Range
V AC (50Hz~400Hz) 600V
V DC 600V
Continuity test: Audible threshold 0~10K
Overload protection: AC/DC 600V
Dimension/wt.: 215x72x36.7mm/235g
Display: Large 1999 count LCD display with function and high voltage
warning indication.
Maximum Voltage Between any Terminal and Earth Ground:
600V DC; 600V AC rms, Over-voltage Category III
Safety: Complies with EN61010-1:2001 for use in over-voltage CAT III
environments
AC Voltage (Volts DC>4.0V)
600V AC maximum
50Hz to 400Hz
220V AC
Accuracy (%rdg. + digits)
+(2.9%+8)
+(1.5%+2)
, Continuity beeper 2KHz.