System Settings; Am/Fm Tuner - Niles ZR-6 Installation Manual

SYSTEM SETTINGS

SETTING UP THE AM/FM TUNER:
The built-in tuner can store up to twenty presets in any combination
of AM or FM stations. In Master/Slave confi gurations, each
tuner could store different presets providing a system total of 60.
However, each keypad can only operate the tuner in the ZR-6
MultiZone Receiver to which it is connected, so each zone has
access to 20 presets.
TO STORE PRESETS IN THE TUNER:
Press the Band button to choose between AM or FM. The display
will show AM or FM to indicate the current band along with the
current station [AM560].
A M 5 6 0
Press the + or – button to tune to the desired station. Each press
and release will increment the tuner frequency up or down. A press-
and-hold initiates the seek function. The tuner will move up or down
to the next station with a clear signal. Continuing to hold the button
will cause the tuner to pause at any station for 3 seconds before
seeking the next station. Releasing the button will stop the seek
function and the tuner will remain on the last tuned station.
F M 9 3 . 1
Once the desired station is displayed, press-and-hold the Set
button for 2 seconds. The display will change to [PRESET XX
SAVE] where XX is the next available open preset.
F M 9 3 . 1
P R E S E T 0 1 S A V E
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
Press the + or – buttons until the desired preset location is
displayed (01 – 20). It will always stop at the fi rst available blank
preset. Press the + or – button to overwrite any previously saved
preset.
F M 9 3 . 1
P R E S E T 0 1
NOTE: IF THE SELECTED PRESET ALREADY HAS A STATION ASSIGNED,
IT WILL BE OVERWRITTEN AND THE NEW STATION WILL NOW BE
STORED IN THAT PRESET LOCATION.
Press-and-hold the Set button for 2 seconds. This will save the
station in the displayed preset location. The ZR-6 MultiZone
Receiver will return to normal operation. The display will show the
station and the preset.
F M 9 4 . 9
P R E S E T 2
Repeat these steps until all desired stations are preset or the
available twenty presets are fi lled.
Presets may be erased one of two ways: by storing a new preset
in the location; or by entering confi guration mode and electing to
erase all presets (see "Erasing Tuner Preset Information").
(CONTINUED ON NEXT PAGE)
51