Maintenance And Troubleshooting - Weslo Pursuit 250 Fm Bike User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, first
see step 6 on page 6 and remove the console from
the upright. Next, see step 5 and insert three batteries
into the console. Reattach the console to the upright,
being careful not to pinch the wires.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the left side shield must be removed.
Turn the Crank (35) to the position shown. Using an
adjustable spanner, turn the Left Pedal (24) clockwise
and remove it. Next, remove the five M5 x 25mm
Screws (52) and the M5 x 20mm Screw (42) from the
Left Side Shield (17). Carefully remove the Left Side
Shield.
52
24
35
42
17
52
Next, locate the Reed Switch (43). Turn the Crank
(35) until the Magnet (38) is aligned with the Reed
Switch. Loosen, but do not remove, the M5 x 15mm
Screw (46). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screw.
Turn the Crank for a moment. Repeat until the con-
sole displays correct feedback. When the Reed
Switch is correctly adjusted, reattach the left side
shield and the left pedal.
35
43
46
11
38