Advertisement
SPOTLIGHT BULB REPLACEMENT:
Use only Vector™ ultra-white, 100 watt, 12 volt halogen replacement
bulbs, designed specifically for the Mega Sport Spot
could result in poor performance and damage to your spotlight. Please read all
instructions before proceeding with bulb replacement. Please contact Vector Technical
Support for replacement bulbs and/or to have bulb replacement service done by
Vector Technical Support. Contact (954) 584-4446 or Toll Free 866-584-5504
WARNING: Disconnect one battery wire before servicing the bulb.
NOTE: DO NOT TOUCH the glass bulb or the inside of the reflector with fingers.
Natural oils from hands can adversely affect performance or cause the bulb to
shatter when heated. Handle the bulb by its metal base only, and after it has
sufficiently cooled.
Refer to Figures A & B (page 5) for Spotlight Bulb and Area Light Bulb Replacement
1. Slide protective rubber bezel forward and remove (Figure A1).
2. Remove both Phillips head screws from plastic front bezel (Figure A2).
3. Carefully remove glass lens and rubber O-ring (Figure A3).
4. Lift out metal reflector containing the two (2) halogen bulbs. (Figures A4).
CAUTION: DURING BULB REPLACEMENT DISCONNECT THE POWER
FROM BOTH LEAD ACID RECHARGEABLE BATTERIES BY
DISCONNECTING THE RED (POSITIVE) TERMINAL
CONNECTORS AT EACH BATTERY (Figures A5 & A6).
PLEASE REFER TO SECTION TITLED BATTERY REPLACEMENT.
5. When replacing bulbs from the twin beam metal reflector (Figure B), simply
squeeze metal spring clip together, lift up and pull bulb out of reflector and
disconnect bulb power cord lead.
6. Disconnect bulb wire from its terminal connection in the housing by holding the
connector firmly and pulling the terminal connector out (Figure B).
7. To install new bulb, hold the bulb by its metal end and insert into the reflector mounting
plate. Align the slots in the bulb base with those in the reflector mounting plate.
8. After bulb is replaced, reassemble all components carefully as shown in Figure A.
WARNING: DO NOT FORGET TO RECONNECT BATTERY TERMINAL
CONNECTORS BEFORE RE-ASSEMBLING. CONNECT RED
WIRE (+)POSITIVE TERMINAL TO BATTERY (+)RED
TERMINAL.
AREA LIGHT BULB REPLACEMENT:
Refer to area light lens cover (Figure A7)
1. Remove single Phillips head screw from lens cover, pull outward from bottom of lens
cover and remove.
2. Simply pull out bulb and snap new bulb in place without touching the glass
bulb lens with your finger. Use a clean cloth to handle the bulb.
NOTE: Only use 12V, 3.6 watt, festoon type bulbs for replacement. Please contact Vector
Technical Support for replacement bulbs (954) 584-4446 or toll free 866-584-5504
3. Replace lens cover by inserting upper lens tab first and push lens back into place.
Replace Phillips head screw.
. Use of any other type bulb
®
4
Hide quick links:
Advertisement
