Page 1
¨ Model No. WLHS26080 Serial No. Write the serial number in the space above for reference. Serial Number Decal QUESTIONS? As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee complete satis- faction through direct assistance...
15. The water pump in the spa jet unit must be primed before you use the DAYBREAK 300 4. Use the DAYBREAK 300 only on a level sur- the first time. You must also prime the pump face. Do not use the spa on carpet or other...
Page 4
DAYBREAK 300, discontinue use using the DAYBREAK 300. and contact a physician. WARNING: Read all instructions before using the DAYBREAK 300. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product. SAVE THESE INSTRUCTIONS...
The warning labels shown below have been placed on the spa cover, printed inside the inflatable spa liner, and placed on the side of the spa jet unit of the DAYBREAK 300. Locate the labels and familiarize yourself with this information. The label on the side of the spa jet unit is an adhesive decal. If this decal is missing, or if it is not legible, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m.
(excluding holidays). To help us assist you, please affordable price. Best of all, the DAYBREAK 300 is note the product model number and serial number fully portable, so you can take it wherever there is an before calling.
CHOOSING A LOCATION FOR THE DAYBREAK 300 There are many factors to consider when choosing a location to set up the DAYBREAK 300. These factors vary depending on whether you use the DAYBREAK 300 inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the DAYBREAK 300.
ASSEMBLY Before beginning assembly, carefully read the ¥ Assembly requires the included air pump. following information and instructions: ¥ Read each assembly step before you begin. ¥ Assembly requires two people. ¥ During assembly, make sure that all parts are ori- ¥...
Page 9
4. Before you fill the DAYBREAK 300, be sure that it is in the position you want, and that it can be easily serviced, if needed. Once the DAYBREAK 300 is filled with water, it will need to be drained to be moved.
USING THE DAYBREAK 300 The DAYBREAK 300 is designed for up to four adults. When connecting the power cord, plug the power cord The four water jets can be regulated to provide a directly into a grounded circuit capable of carrying 15 relaxing massage to sooth away stress, and the or more amps.
Page 11
and 1/3 of the ÒNon-chlorine ShoxÓ bottle to the water SECURING THE SPA COVER in the spa. Allow the water to circulate for five min- utes. You should now test the pH level of the water. The spa cover can be secured by snapping the latch- Use the included test strips to check the pH of the es on the spa cover into the buckles on the side pan- water.
Page 12
To drain the DAYBREAK 300, you must use a garden hose to siphon the water. Place one end of the hose in the spa and hold it in front of a hydro- therapy jet until there is a flow of water coming out of the hose.
You should maintain a slightly alkaline pH hose. If the filter still is dirty, you will need to level, between 7.2 and 7.8, in the DAYBREAK 300. soak it in a cleaning solution which can be obtained from a pool and spa supply store.
Check to see if the GFCI breaker is tripped, or ature. was not turned on. Reset the GFCI breaker. b. If you are using the DAYBREAK 300 outdoors, 2. SYMPTOM: THE CIRCUIT BREAKER OR GFCI it may take longer for the water to heat. See...
Page 15
If rapid water loss occurs, or if you notice wet- PRIMING THE SPA JET UNIT on page 10). ness on the floor around the DAYBREAK 300, then the liner may have a leak. Locate the leak, 10. SYMPTOM: THE SPA JET UNIT CONTINUES...
Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be pre- pared to give the following information when calling: 1. The MODEL NUMBER of the product (WLHS26080). 2. The NAME of the product (WESLO ¨ DAYBREAK 300).
Page 17
PART LISTÑModel No. WLHS26080 R0398A Key No. Qty. Description Key No. Qty. Description Power Cord Grommet Rubber Insulator Motor Cap Screw Washer Dual Temperature Probe Primer O-ring Support Ball (Set) Rubber Damper Clamp Screw Wire Harness Clamp Air Control Knob Bolt On/Off Switch Assembly Fabric Spa Surround...