Table of Contents
Advertisement
._+4.--"
-
.-
-
-
0
Range Top Burners
The holes in the burners must be
kept clean at all times for proper
ignition and an even, unhampered
flame,
Clean the burners routinely and
especially after bad spillovers
which could clog these holes.
Burners lift out for cleaning.
Note: Two screws hold each burner
pair in place to keep them from
wobbling around during shipment.
~ Remove and discard the shipping
@
crews and lift the burners up and
out. This disengages them from the
mounting bracket under each
burner pair.
To remove burned-on food, soak
the burner in a solution of a product
used for cleaning the inside of coffee
makers. Soak the burner for 20 to
30 minutes. If the food doesn't
rinse off completely, scrub it with
soap and water or a mild abrasive
cleanser and a damp cloth.
Do not attempt to clean burners in
an automatic dishwasher. Loosened
food soil can clog burner holes,
and the caustic action of the
dishwasher detergent can damage
the burner heads.
Before putting the burner back, dry
it thoroughly by setting it in a warm
oven for 30 minutes. Then place it
back in the range, making sure it is
properly seated on the mounting
bracket and is level.
Control F%mels
It's a good idea to wipe the control
panels clean after each use of the
oven, For a more thorough cleaning,
the control knobs can be pui.led off-
the knob stems and, on models so
equipp@ tie glass upper control
panel can be cleaned on both sides.
B=-
To remove the glass panel:
1. Remove the screw on each end of
the backsplash.
2. Remove the metal strips on each
end that hold the glass in place.
3. Remove the clock knob and nut
securing the light switch.
4. Carefidly remove the glass and
place it on a smooth, flat surface.
Clean it with miid soap and water,
rinse with clean water and dry with
a soft cloth. Caution: Do not use
abrasive cleansers, strong liquid
cleaners or oven cleaners. on glass or
enamel control panel surfaces—they
will darnage the finish.
Outer Enamel Finish
When the range is cool, wash the
enarnel finish with mild soap and
water or a mild abrasive cleanser
applied with a damp cloth. Rinse
with clean water and dry with a soft
cloth. If you wish, occasionally
apply a thin coat of mild cleaning
wax to help protect the finish.
To avoid marring the surface of
the range and to prevent it from
becoming dull, don't slide heavy
pans across it. If you spill fds
with
a lot of acid or high sugar content,
clean them up as soon as possible. If
allowed to remain, these fds
could
cause a dull spot. Also, never use
harsh abrasive cleansers. They could
permanently damage the enamel
surface.
-'
Advertisement
Table of Contents
