Table of Contents
Advertisement
Care and Cleaning
(See Cleaning Guide)
Proper care and cleaning are
proper maintenance.
and
Cooktop
sturdy but breakable if misused.
This t'inish is acid-resistant.
However, any food spills with a
high acid content (such as fnlit juices,
permitted to remain on the finish.
Cleaning Under the Range
The area
the range of models
equipped with a bottom drawer can
removing the bottom drawer. To
remove,
and remove
way, tilt Llp the front
it. To replace. insert glides at back
insert easily. Let front of drawer
Removable Oven Door
To REMOVE door, open to BROIL
position. or where yoLl feel hinge
catch slightly. Grasp door at sides:
lift door up and away from hinges.
To REPLACE, grasp door at sides.
Line
door
with hinges and push
door firmly into place.
22
Oven Vent Duct
Your range is vented through a
duct located under the right rear
surface unit. Clean the duct often.
Make sure
Lift
right rear surface unit.
Remove drip pan/trim ring.
Lift out oven vent duct.
To replace:
Place the part over the oven vent
located below the cooktop with
opening of the duct under the
round opening in the drip pan. It is
important that the duct is in the
correct position so moisture and
vapors from the oven can be
Never cover the hole in the oven
vent duct with aluminum foil or
1
any other material. This prevents
the oven vent from working
properly during any cooking cycle.
Lamp Replacement
CAUTION: Before replacing
your oven lamp bulb, disconnect
the electric power for your range
at the main fuse or circuit
breaker panel. Be sure to let the
lamp cover and bulb cool
completely before removing or
replacing them.
The oven
(bulb) is covered
with a glass removable cover which
is
wire. Remove oven door, if desired,
to reach cover easily.
To remove:
. Hold hand under cover so it
doesn't fall when released. With
fingers of same hand, firmly push
back wire bail until it clears cover.
Lift off cover. DO NOT REMOVE
ANY SCREWS.
. Replace bulb with 40-watt home
appliance bulb.
To replace cover:
Place it into groove of lamp
receptacle. Pull wire bail forward to
center of cover until it snaps into
place. When in place, wire holds
cover firmly. Be certain wire bail is
in depression in center of cover.
. Connect electric power to range.
Surface Units
Clean the area under the drip
catch
To make cleaning easier, tilt-lock
units lift up and lock in the up
position, and plug-in units
are removable.
Caution: Be sure all controls are
turned to OFF and surface units
are cool before attempting to lift
or remove them.
After 1 ifting the tilt-lock unit or
removing a plug-in unit, remove
the drip pardtrim rings and clean
them according to directions in the
Cleaning Guide. Wipe around the
edges of the surface unit opening.
Clean the area below the unit.
Rinse all washed areas with
a damp cloth or sponge.
-
fire.
Advertisement
Table of Contents
