Playing Tunes; Diagnostics Quick Reference Charts; Fault Display/Download Mode - Fisher & Paykel DishDrawer DS605 Diagnostic Service Manual

599464
The DishDrawer™ is still in the Showroom wash mode however, and it can be
re-run by pressing POWER and then START/PAUSE.
off/showroom wash mode has been initiated, the mains power must be
removed to exit out.

Playing Tunes

3.10
Once in showroom mode, pressing the START/PAUSE button for 3 seconds
will start a tune playing. Pressing the START/PAUSE button again will toggle
the tune between Bach and the Star Spangled Banner. This feature is not
widely known about, may not be present in all models and may be removed in
future products.

DIAGNOSTICS QUICK REFERENCE CHARTS

4

Fault Display/Download Mode

4.1
Press and hold KEYLOCK, then START/PAUSE for 5 seconds.
All LEDs & LCD segments except Keylock are illuminated.
Press START/PAUSE.
This initiates pen data download via the lower tub-home light pipe. At the
same time the current and then the previous fault code will be displayed in
the LCD screen and on the secondary control panel LEDs. To read the
fault code on the secondary display, refer to Section 4.7 on fault codes.
Press KEYLOCK.
This will clear current fault code. Note: If Keylock is pressed again, the
previous fault code will be cleared. Pressing Keylock also toggles the wash
icons on the LCD on and off.
Press POWER to exit.
14
Once show