Pioneer AVIC-X1R Installation Manual page 7

• Never connect speakers with an output rating of less than 50 W channel or impedance
outside of the 4 ohms to 8 ohms specifications to your Navigation system. Connecting
speakers with output and/or impedance values other than those noted here may result in
the speakers catching fire, emitting smoke, or becoming damaged.
• When the ignition switch is turned on (ACC ON), a control signal is output through the
blue/white lead. Connect to an external power amp's system remote control terminal
(max. 300 mA 12 V DC). The control signal is output through the blue/white lead, even
if the front panel is detached, or the audio source is switched off.
• When an external power amp is being used with this system, be sure not to connect the
blue lead to the amp's power terminal. Likewise, do not connect the blue lead to the
power terminal of the auto aerial. Such connection could cause excessive current drain
and malfunction as well as damage to the auto aerial of the vehicle.
Parts supplied
Display unit
Connector
Extension lead
(for speed signal)
System extension connector
Hide-away unit
30-pin cable
GPS aerial
Lock tie
Power cord
Extension lead
(for reverse signal)
Extension aerial cable
6