GE 183D5580P236 Owner's Manual & Installation Instructions page 39

7 INSTALL THE ANTI-TIP DEVICE
(cont.)
D
For wood construction, drill a pilot hole
at an angle of 20° from the horizontal.
A nail or awl may be used if a drill is not
available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction,
you will need a 1/4 x 1
a 1/2 O.D. sleeve anchor, which are not
provided. Drill the recommended size
hole for the hardware.
Wallboard
Anti-Tip
device
Install the sleeve anchor into the drilled
hole and then install the lag bolt through
the device. The bolts must be properly
tightened as recommended for the
hardware.
E
Slide the range against the wall, and
check for proper installation by grasping
the front edge of the cooktop and
carefully attempting to tilt the range
forward. The bracket should stop the
range within 4 inches. If it does not,
the bracket must be reinstalled.
Installation Instructions
1 ⁄ lag bolt and
2
Back of
range
Wood screw
WHEN ALL HOOKUPS ARE
COMPLETED
Make sure all controls are left in the OFF
position. Make sure the flow of combustion
and ventilation air to the range is
unobstructed.
CONVERT TO LP GAS (or convert back
to natural gas from LP)
This range leaves the factory set for use
with natural gas. If you want to convert to LP
gas, the conversion must be performed by a
qualified LP gas installer.
The conversion instructions and LP orifices
can be found attached to the range next to
the pressure regulator.
Keep these instructions and the orifices in
case you want to convert back to natural gas.
39