Miller Electric MOG-200C Owner's Manual page 12

1
WARNING
ELECTRIC SHOCK can kill; TWO TIMES
NORMAL OPEN-CIRCUIT VOLTS exists
between electrode holders of opposite
polarity.
Do not touch live electrical parts.
Do not touch electrode holders of opposite polarity
at the same time.
Separate electrode holders of opposite polarity to
prevent contact.
See ANSI Z49.1 and OSHA TITLE 29, CHAPTER
XVII, PART 1910, Subpart Q.
OM-805 Page 6
2 3
Figure 4-2. Safety Equipment
1
Figure 4-3. Work Clamp
Figure 4-4. Optional Polarity Switch
Wear the following while welding:
1
2
3
1
Connect work clamp to a clean,
Tools Needed:
paint-free location on workpiece, as
close to weld area as possible.
Use wire brush or sandpaper to
clean metal at weld joint area. Use
chipping hammer to remove slag
after welding.
ARCING can damage switch.
Do not change Polarity switch position while welding
or under load.
Arcing inside switch can damage contacts, causing
switch to fail.
1
Use switch to select polarity of weld
output.
For Direct Current Electrode Nega-
tive (DCEN), use Straight (STR)
position.
1
For Direct Current Electrode Posi-
tive (DCEP), use Reverse (REV)
position.
Dry, Insulating Gloves
Safety Glasses With Side
Shields
Welding Helmet With Correct
Shade Of Filter (See ANSI
Z49.1)
sb3.1 1/94
Work Clamp
sb4.1 2/93
warn5.1* 293
Polarity Switch
Ref. ST-047 549-E