Page 1
MCM772 Register your product and get support at EN User manual FR Mode d’emploi DA Brugervejledning Manuale utente DE Benutzerhandbuch NL Gebruiksaanwijzing ES Manual del usuario SV Användarhandbok...
Contents 6 Adjust volume level and sound effect Adjust volume level Select a preset sound effect 1 Important Enhance bass Safety Select automatic loudness control Hearing safety Mute sound Notice Listen through headphone Disposal of old equipment and Used batteries 7 Tune to FM radio stations Program radio stations automatically 2 Your Micro Hi-Fi Sytstem...
1 Important g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such Safety as radiators, heat registers, stoves, or other apparatus (including amplifi ers) that Know these safety symbols produce heat.
Page 5
• Connect the brown wire to the terminal m Unplug this apparatus during lightning marked L or coloured red. storms or when unused for long periods • Do not connect either wire to the earth of time. terminal in the plug, marked E (or e) or n Refer all servicing to qualifi...
“comfort level” adapts to higher device that are not expressly approved by volumes of sound. So after prolonged Philips Consumer Electronics may void the listening, what sounds “normal” can actually user’s authority to operate the equipment. be loud and harmful to your hearing. To...
Disposal of old equipment and Used This symbol might be used in combination with a chemical symbol. In this case it complies with batteries the requirement set by the Directive for the Information for Users on Collection and chemical involved. Disposal of Old Equipment and Used Batteries Environmental information All redundant packing material has been...
• Flat control cable Congratulations on your purchase, and • Loudspeaker boxes x 2 welcome to Philips! To fully benefi t from the • Speaker cables x 2 support that Philips offers, register your product • Remote control with battery at www.Philips.com/welcome.
Overview of the remote a STANDBY-ON • Turn on the audio system, switch control to standby mode, or switch to Eco Power Standby. • Socket for a USB mass storage device. c IR sensor d Display panel • Show current status. e Disc tray •...
Page 11
• Program radio stations. • Turn on the audio system, switch o Numeric keypad to standby mode, or switch to Eco • Select a track from a disc directly. Power Standby. p ALBUM +/- b Source selection keys ( CD , USB , FM , •...
Connect FM antenna Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial numbers. Find the model number and serial number of this audio system at the back or the bottom of your audio system.
Connect power Note • Before pressing any function button on the remote Caution control, fi rst select the correct source with the remote control instead of the main unit. • • If you are not going to use the remote control for a Risk of product damage! Ensure that the power supply long time, remove the battery.
Page 14
The clock (if set) appears on the » display panel. The blue Eco Power indicator turns off. »...
4 Play disc/USB Press / to select a fi le. Press to start play. Play from disc Press CD to select the CD source. Press on the front panel. The disc tray opens. » Place a disc onto the tray and press . Ensure that the label is facing upwards.
5 Control play The track number and total remaining » play time For MP3 disc: Press DISPLAY to display ID3 information Skip to a track (if available). For CD: Press / to select another track. Repeat play • To select a track directly, you can also press a key on the numerical keypad.
Press / to select a track number to program, then press PROGRAM to confi rm. • To select a track in an MP3 disc or USB device, fi rst press ALBUM +/- to select the album where the track is located.
6 Adjust volume During play, press LOUD to enable/disable automatic loudness control. level and sound effect Mute sound During play, press MUTE to mute/unmute sound. Note • You cannot use the DSC, DBB and Loudness features Listen through headphone at the same time. Plug a headphone into the socket on the audio system.
7 Tune to FM Program radio stations manually radio stations Note Ensure that you have connected and fully • You can program a maximum of 20 preset radio stations. extended the supplied FM antenna. Press FM . Tune to a radio station. Press and hold Press PROGRAM to activate programming.
When automatic programming is used, RDS stations are programmed fi rst. Tune to a RDS station. Press RDS repeatedly to scroll through the following information (if available): Station name » Program type such as [NEWS] (news(, » [SPORT] (sport), [POP M] (pop music)...
8 Use more of Connect other devices your audio Caution system • Before connecting any other device to the audio system, ensure that you have disconnected the power adaptor of the audio system. Set the alarm timer Note Ensure that you have set the clock correctly.
9 Product Speakers Speaker Impedance 4ohm information Speaker Driver 4” woofer + 1” tweeter Sensitivity >82dB/m/W Note General information • Product information is subject to change without prior AC power 220 - 230V, 50Hz notice. Operation Power Consumption Standby Power <4W Consumption Specifi...
RDS program types • WMA v9 or earlier • Directory nesting up to a maximum of 8 levels NO TYPE No RDS programme • Number of albums/ folders: maximum type NEWS News services • Number of tracks/titles: maximum 999 AFFAIRS Politics and current affairs •...
Replace the battery. requesting service. If the problem remains • Aim the remote control directly at the unsolved, go to the Philips web site (www. sensor on the front of the audio system. Philips.com/support). When you contact Philips, No disc detected ensure that your audio system is nearby and the •...