Jp14 Clear Cmos; Installing Cpu - AOpen MX4BS Easy Installation Manual

Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
User's Manual can be found in the
Bonus Pack CD Disc. Thanks for
the help of saving our earth.
Motherboard x 1
40-Wire IDE Cable x 1
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
Bonus Pack CD x 1
This Easy Installation Guide x 1
Retention Module
PART NO: 49.37P02.031 DOC. NO: MX4BS-EG-E0108B
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin1 & pin2.
Online
5. Connect ATX power cable back to connector PWR2.

1. JP14 Clear CMOS

Pin 1
1 1
Normal Clear CMOS
(default)

2. Installing CPU

1.
2.
3.
CPU Pin 1 and cut edge
CPU socket lever
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking...
2. Forget password...
3. Troubleshooting...
Pull up the CPU socket lever and up to
90-degree angle.
Locate Pin 1 in the socket and look for a
(golden) cut edge on the CPU upper interface.
Match Pin 1 and cut edge. Then insert the
CPU into the socket.
Press down the CPU socket lever and finish
CPU installation.
Note: If you do not match the CPU
socket Pin 1 and CPU cut edge well,
you may damage the CPU.