3 Get started
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Place on a flat surface
Before you place the micro Hi-Fi system on a
flat surface, attach the supplied base bracket.
1
Place the micro Hi-Fi system face-down on
a flat surface.
2
Insert the base bracket into the two slots
on the bottom of the unit.
3
Push the bracket downward to fit into the
slots until it locks into place.
Tip
•
You can also mount the unit on a wall.
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Risk of decreased battery life! Never mix different
brands or types of batteries.
•
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one AAA battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Connect power adapter
Caution
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the Micro Hi-Fi system.
•
Risk of electric shock! When you unplug the power
adapter, always pull the plug from the socket. Never
pull the cord.
Connect the power adapter to the wall socket.
» The red standby indicator turns on.
» The unit is ready to be set up for use.
EN
8