Table of Contents
Advertisement
ALTERNATE CONSTRUCTION PREPARATION
A
OPTIONAL MAINTOP FILLER OR
BACKGUARD KIT
If counter opening extends to the wall, it will
require Maintop Filler Kit (JXS66XX) or
Backguard Kit (JXS32XX) to close the gap.
NOTE: If the countertop is greater than 25",
it will show a gap between the backguard
and wall or between filler kit and the wall.
If the countertop is less than 25", a gap will
occur between the countertop front and the
control panel ends. (See page 10, Step 3).
Wall
9/16"
Must be
smooth cut
flat
Must be level
Refer to the Filler or Backguard Kit instructions
for Installation details.
Installation Instructions
Must be
25"
level
9/16"
30"
Must be
flat
B
ISLAND INSTALLATION
When installing in an island or other
non-standard location, countertop cutout
dimensions must be according to page 5.
For the anti-tip bracket instructions, see
page 9.
In this application, do not use Backguard Kit
(JXS32XX).
CABINETS OVER THE RANGE
C
LESS THAN 30"
If a 30" clearance between cooking surface
and overhead combustible material or metal
cabinets cannot be maintained, protect the
underside of the cabinets above the cooktop
with not less than 1/4" insulating millboard
covered with sheet metal not less than 0.0122"
thick.
CABINET CUTOUT HEIGHT
D
MORE THAN 27-1/2" USE
LOWER TRIM KIT
Optional Lower Trim to fill space beneath
27-1/2" min. requirement (see page 4).
Use lower Trim Kit JXS96XX.
14
Advertisement
Table of Contents
