Table of Contents
Advertisement
GENERAL
INTRODUC'TION
SCOPE OF THIS MANUAL
ns are recommended for
This manual i? intended for use by experienced
v
technicians familiar with similar types of commercial
one is within t w o feet (0.6
grade communications equipment. It contains all re-
quired service information for the equipment and is
ransmit until all
RF
connectors are verified
current as of the publication data. Changes which may
ectors are properly termi-
occur after publication are covered by either Service
Bulletins or Manual Revisions. These are issued as re-
DO NOT operate this equipment
quired.
lasting caps or in an explosive at-
ORDERING REPLACEMENT PARTS
properly grounded before
When ordering replacement parts or equipment in-
formation, the full part identification number should be
erviced by a qualified
technician only.
included. This applies t o all parts : components, kits, or
chassis. If the part number is not known, include the
chassis or kit number of which it is a part, and a suffi-
cient description of the required component for proper
identification.
PRE-INSTALLATION CONSIDERATIONS
1. UNPACKING
Unpack the radio from its shipping container and
check for accessory items. If any i t e m is missing,
please contact KENWOOD immediately.
2.
LICENSING REQUIREMENTS
Federal regulations require a station license for each
radio installation (mobile or base) be obtained by the
equipment owner. The licensee .is responsible for en-
ring transmitter power, frequency, and deviation are
hin the limits permitted by the station license.
ansmitter adjustments may be performed only by
nsed technician holding an FCC first, second or
ss commercial radiotelephone operator's li-
re is no license required t o install or operate
FCC COMPLIANCE AND TYPE NUMBERS
3. PRE-INSTALLATION CHECKOUT
3-1. Introduction
Each rad~o
IS
adjusted and tested before shipment.
However, it is recommended that recerver and trans-
mitter operation be checked for proper operatron be-
fore ~nstallat~on.
3-2.
Testing
The radio should be tested complete with all cabl~ng
and accessories as they wrll be connected In the f ~ n a l
installatron. Transmrtter frequency, d e v ~ a t ~ o n , and
power p ~ t p u t should be checked, as should recelver
~ g n ~ j t i v i t y , squelch operation, and audio o u t p u t ,
' Q ~ ~ e q u i p r n e n t
operation should be verif~ed.
Complrance
Part 90
Part 90
Type acceptance number
ALHTK-940-1
ALHTK-941-1
Frequency range
806-870MHz
896-941 MHz
Hide quick links:
Advertisement
Table of Contents
