Rear Wheel - Yamaha YZ85(D) Owner's Manual

Table of Contents

Advertisement

PERIODIC MAINTENANCE AND ADJUSTMENT
3. Lower the front wheel so that it is
on the ground, install the remov-
able sidestand, and then rest the
motorcycle on it.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
70 Nm (7.0 m·kgf, 51 ft·lbf)
7

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the rear wheel off the ground
according to the procedure on
page 7-27.
3. Fully loosen the locknut, and then
loosen the drive chain slack ad-
justing bolt on each side of the
swingarm.
4. Remove the axle nut and washer.
7-29
EAU25080
EAU41313
EWA10821
1. Axle nut
2. Washer
3. Locknut
4. Drive chain slack adjusting bolt
5. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
TIP
If the drive chain is difficult to re-
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
The drive chain does not need to
be disassembled in order to re-
move and install the rear wheel.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yz85lwdYz85Yz85lw

Table of Contents