HP 6125XLG Configuration Manual page 75

Blade switch acl and qos configuration guide

Hide thumbs Also See for 6125XLG:

Table of Contents

[PE1-Ten-GigabitEthernet1/1/5] port hybrid vlan 100 untagged

# Apply QoS policy test to the incoming traffic of the downlink port Ten-GigabitEthernet 1/1/5.

[PE1-Ten-GigabitEthernet1/1/5] qos apply policy test inbound

[PE1-Ten-GigabitEthernet1/1/5] quit

# Configure the uplink port Ten-GigabitEthernet 1/1/6 as a trunk port, and assign it to VLAN 100.

[PE1] interface ten-gigabitethernet 1/1/6

[PE1-Ten-GigabitEthernet1/1/6] port link-type trunk

[PE1-Ten-GigabitEthernet1/1/6] port trunk permit vlan 100

[PE1-Ten-GigabitEthernet1/1/6] quit

Configuring PE 2

Configure PE 2 in the same way PE 1 is configured.

Table of Contents