Enabling Dhcp; Enabling The Dhcp Server On An Interface - HP 6125XLG Configuration Manual

Step
2. Enter DHCP address pool
view.
3. Configure a self-defined
DHCP option.
Table 2 Common DHCP options
Option
3
6
15
44
46
66
67
43

Enabling DHCP

You must enable DHCP to validate other DHCP configurations.
To enable DHCP:
Step
1. Enter system view.
2. Enable DHCP.

Enabling the DHCP server on an interface

Perform this task to enable the DHCP server on an interface. Upon receiving a DHCP request on the
interface, the DHCP server assigns an IP address and other configuration parameters from the DHCP
address pool to the DHCP client.
To enable the DHCP server on an interface:
Step
1. Enter system view.
2. Enter interface view.
Command
dhcp server ip-pool pool-name
option code { ascii ascii-string | hex
hex-string | ip-address
ip-address&<1-8> }
Option name
Router Option
Domain Name Server Option
Domain Name
NetBIOS over TCP/IP Name
Server Option
NetBIOS over TCP/IP Node
Type Option
TFTP server name
Boot file name
Vendor Specific Information
Command
system-view
dhcp enable
Command
system-view
interface interface-type interface-number
Corresponding
command
gateway-list
dns-list
domain-name
nbns-list
netbios-type
tftp-server
bootfile-name
N/A
40
Remarks
N/A
By default, no self-defined DHCP
option is configured.
Recommended option
command parameters
ip-address
ip-address
ascii
ip-address
hex
ascii
ascii
hex
Remarks
N/A
By default, DHCP is disabled.
Remarks
N/A
N/A