Gigabyte GA-H61M-S User Manual page 13

5) SATA2 0/1/2/3 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
1 7
SATA2
0 1
2 3
7 1
6) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, and system status indicator on the chassis to this header according
to the pin assignments below. Note the positive and negative pins before connecting the cables.
Power/Sleep LED Power Switch
2 10
1 9
Hard Drive Reset Switch
Activity LED
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch,
power LED, hard drive activity LED and etc. When connecting your chassis front panel module to this header,
make sure the wire assignments and the pin assignments are matched correctly.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
• PLED (Power/Sleep LED):
Connects to the power status indicator on the
System Status LED
chassis front panel. The LED is on when the
S0 On
system is operating. The LED is off when the
S3/S4/S5 Off
system is in S3/S4 sleep state or powered
off (S5).
• PW (Power Switch):
Connects to the power switch on the chassis front panel. You may configure
the way to turn off your system using the power switch (refer to Chapter
2, "BIOS Setup," "Power Management," for more information).
• HD (Hard Drive Activity LED):
Connects to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
• RES (Reset Switch):
Connects to the reset switch on the chassis front panel. Press the reset
switch to restart the computer if the computer freezes and fails to perform
a normal restart.
• NC:
No connection.
- 13 -