Toshiba 46WL700A Owner's Manual page 24

• Game mode is available in external input mode
(other than aerial input). When you select Game
mode, suitable widescreen formats will be
selected.
• PC mode is available in RGB/PC input mode or
HDMI input mode.
• The Picture mode you select affects the current
input only. You can select a different picture mode
for each input.
Resetting the Picture Mode
This feature resets all picture settings to the factory
settings Picture Mode �
Note:
If no picture settings have been changed, Reset is
not available.
1
From the PICTURE menu, press s or r to select
Reset , and then press
2
A confi rmation message will appear. Press v or w to
select Yes , and then press
Activating the picture preferences
You can customise current Picture Mode settings as
desired� For example, while selecting " Dynamic ," if
you change the following items, such as Backlight ,
Contrast , Brightness , Colour , Tint , Sharpness
and the Advanced Picture Settings items, your new
setting are saved for " Dynamic " Picture Mode �
1
From the PICTURE menu, press s or r to select
either Backlight , Contrast , Brightness , Colour ,
Tint or Sharpness �
2
Press v or w to adjust the settings as desired�
Note:
Contrast are not available when Picture Mode is
set to AutoView.
Adjusting Black/White Level
Black/White Level improves the contrast of the picture�
1
From the PICTURE menu, press s or r until
Advanced Picture Settings is selected�
PICTURE
Contrast
Brightness
Colour
Tint
Sharpness
Advanced Picture Settings
Expert Picture Settings
Control Visualization
24
Using the TV's features (General)
�
�
100
0
0
0
0
2
Press , and then press s or r to select Black/
White Level �
Advanced Picture Settings
3D Colour Management
PICTURE
Base Colour Adjustment
Colour Temperature
Auto Brightness Sensor Settings
Active Backlight Control
Black/White Level
Static Gamma
Noise Reduction
3
Press v or w to adjust the settings as desired�
Note:
If Picture Mode is set to AutoView, the range will be
-5 to +5.
Using ClearFrame 200Hz
The ClearFrame 200Hz anti-blur technology doubles the
frame rate from 50 frames per second to 200 frames per
second, virtually eliminating motion blur without adding
fl icker or reducing image brightness.
1
From the Advanced Picture Settings menu, press
s or r until ClearFrame 200Hz is selected�
2
Press v or w to select On or Off �
Adjusting Film Stabilization
The Film Stabilization function improves motion
smoothness�
1
From the Advanced Picture Settings menu, press
s or r until Film Stabilization is selected�
2
Press v or w to select High , Middle , Standard or
Off �
Adjusting the Colour Temperature
Colour Temperature increases the 'warmth' or
'coolness' of the picture by increasing the red or blue tint�
1
From the Advanced Picture Settings menu, press
s or r to select Colour Temperature �
2
Press v or w to adjust the settings as desired (0 (warm)
- 10 (cool))�
Note:
If Picture Mode is set to AutoView, the range will
be -5 to +5.
Adjusting the Auto Brightness Sensor
When the Auto Brightness Sensor is activated, it
will automatically optimise the backlighting levels to suit
ambient light conditions�
1
From the Advanced Picture Settings menu, press
s to select Auto Brightness Sensor Settings ,
and then press �
Off
7
On
7
0