Control Center Configuration; Usb Printer - NETGEAR N300 User Manual

Control Center Configuration

Select Tools >Configuration to display the following screen:
Automatically execute when logging on Windows. Enable this utility to start automatically
when you are logged in to Windows.
Timeout. Specify the timeout value for holding the USB resource when it is not in use.
Language. Select the display language for this utility.

USB Printer

The first time you use a printer, you need to click Connect. You might be asked to install the
driver for this printer. After the driver is installed, the printer status changes to Available.
Note: Some USB printers (for example: HP and Lexmark printer) request
that Do not connect the USB cable until you are prompted by the
installation software in their installation.
If the USB printer is detected and connected automatically, you need to disconnect the
printer, and then wait for the prompt asking you to click Connect.
N300 Wireless Gigabit Router with USB JNR3210
ReadySHARE Printer
61