Access Point Mode - Edimax EW-7438RPn V2 Quick Installation Manual

V. WPS
If your wireless router/access point supports WPS (Wi-Fi Protected Setup)
then you can use this method to setup your wireless extender.
1.
Press the WPS button on your wireless router/access point to activate its
WPS.
Please check the instructions for your
wireless router/access point for how long
you need to hold down its WPS button.
2.
Within two minutes, press and hold the WPS
button on the wireless extender for two
seconds. The extender's
should flash to indicate that WPS is in
progress.
3.
The devices will establish a connection. The extender's
should display on for 5 minutes to indicate a successful connection.
VI. Access Point Mode
If you are using the EW-7438RPn in "Access Point" mode, please ensure you
connect the device to your existing router using an Ethernet cable as shown
below:
Select "Access Point" mode during setup (refer to II. Installation Step 5) and
follow the on screen instructions. When setup is complete, connect your Wi-Fi
device to your access point's new SSID.
green WPS LED
11
green WPS LED