Page 1
INNOTECH SYSTEMS INC. Universal Infrared Remote Control From any PC! "SpitFIRE" Serial Port Interface IR Engine Serial Port Interface IR Engine...
A mini-phone plug located in the rear permits the use of mini stick--on IR emitters or IR blasters for maximum flexibility. The small (3¼" x 5¼") SpitFIRE may be situated behind or near the PC, and is connected via a conventional serial cable to the PC. Sample software is included.
The auto- simulated button presses to it. The SpitFIRE will respond by returning repeat range is from 1 to 8 messages. A setting of 0 tells the SpitFIRE to status information for every command.
‚ PROGRAM Transmit IR twice (Return 2 flashes) The SpitFIRE includes a visible front panel LED that will flash to indicate Transmit IR three times (Return 3 flashes) the progress of the programming sequence. The visible LED flash informa- Transmit IR four times...
In fact, if the button- The SpitFIRE will respond to programming codes rapidly. At the end of the press bit is set to 0, the scan code portion of the command is ignored.
AutoSearch cancels itself after running through all its codes (returns 0 flashes) If the SpitFIRE is set up to transmit IR continuously, (default state or scan- code 50h) it will transmit the test message 4 times. If it is set up to trans-...
Page 8
The programming sequence to manual search the code for source #1 is: The SpitFIRE will return a flash count of 0 to 9 to indicate the digit. Example: To read the ISI number of the TV slot Button function...
Visible LED flash count VCRs do. If the last SOURCE button pressed was TV, and the user presses Status message PLAY, punch-thru allows the SpitFIRE to press PLAY on a source that does DAT3-0 Status messages (MOD=11) have a PLAY button without first switching to it.
Page 10
The source selection and transmission instructions stay in effect until they are changed. When infrared is actually transmitted, the SpitFIRE may take significantly longer to issue a status response to the next button than when infrared is not being issed . If an undefined scancode is issued, the device will respond with an error scancode.
008, 176, 358 Infinity Following is a list of device codes to be used when manually programming 273, 136, 157, 353 the SpitFIRE. Kenwood Note that the first codes for an appliance brand are the latest models, and Kloss the later codes are older models. In addition to TV, VCR, Cable, and Kloss Novabeam Satellite, a limited number of DVD functions are included.
Page 12
Zonda 263, 029 Scott 049, 025, 132, 010 Sears 128, 018, 147, 133, 139, 019, 148, 081, 153, 156, 001, 025 Sharp 142, 020, 132, 017 Signature 2000 SpitFIRE Innotech Systems Inc. Page 23 SpitFIRE Innotech Systems Inc. Page 24...