Table of Contents
Advertisement
144
Universal Garage Door Opener
Programming
Note: Put a new battery in the hand-held transmitter. This will ensure
quicker training and accurate transmission of the radio-frequency signal.
3. Using both hands, simultaneously press and hold the desired
HomeLink button and the hand-held transmitter button. DO NOT release
either one until the HomeLink indicator light flashes slowly and then
rapidly. When the indicator light flashes rapidly, both buttons may be
released. The rapid flashing indicates successful training.
4. Press and hold the HomeLink button you programmed for 5 seconds,
then release. You may need to do this twice to activate the door. If your
garage door does not operate, watch the HomeLink indicator light.
If the indicator light stays on, the programming is complete. Press and
release the programmed HomeLink button, and then begin programming
your garage door opener. See below for Steps 5 – 7.
If the indicator light flashes rapidly for 2 seconds and then turns to a
constant light, the HomeLink button is not programmed yet. Do the
following:
Press and hold the HomeLink button while you press and release the
hand-held transmitter button every 2 seconds. The HomeLink indicator
light will flash slowly and then rapidly once the HomeLink function
button recognizes and accepts the hand-held transmitter's radio
frequency signal.
2013 MKX (mkx)
Owners Guide gf, 3rd Printing
USA (fus)
1. With your vehicle parked outside
of the garage and your key in the
ignition, turn the key so that the
ignition is in the on position.
2. Hold your hand-held, garage
door transmitter 1–3 inches
(2–8 centimeters) away from
the HomeLink button you want
to program.
Advertisement
Table of Contents
