Edit Or Delete A Port Forwarding Entry - NETGEAR AC1450 User Manual


To add a custom service:
1. Select Advanced > Advanced Setup > Port Forwarding/Port Triggering.
2. Select the Port Forwarding radio button as the service type.
3. Click the Add Custom Service button.
4. In the Service Name field, enter a descriptive name.
5. In the Service Type field, select the protocol. If you are unsure, select TCP/UDP.
6. In the External Starting Port field, enter the beginning port number.
• If the application uses a single port, enter the same port number in the Ending Port
field.
• If the application uses a range of ports, enter the ending port number of the range in
the External Ending Port field.
7. Specify the internal ports by one of these methods:
• Leave the Use the same port range for Internal port check box selected.
• Fill in the Internal Starting Port and Internal Ending Port fields.
8. Fill in the Internal IP address field, or select the radio button for an attached device listed in
the table.
9. Click Apply.
The service appears in the list in the Port Forwarding/Port Triggering screen.

Edit or Delete a Port Forwarding Entry


To edit or delete a port forwarding entry:
1. Select Advanced > Advanced Setup > Port Forwarding/Port Triggering.
2. Select the Port Forwarding radio button as the service type
3. In the table, select the radio button next to the service name.
4. Click Edit Service or Delete Service.
AC1450 Smart WiFi Router
Security
69