Handset Synchronization - GE 28321 User Manual

Handset Setup
10
4. Press to enter the menu and start the
handset registration. Wait Base searching
1"is displayed. If the handset has located
the base, it may display (depending on
EEPROM settings), the base identification
number (RFPI).
5. Handset Registered is displayed and the
handset goes back to idle.
6. The DECT indicator light on the Base stops
flashing when a handset has successfully
been registered.
If the handset does not locate the base, it goes
back to idle mode. Try again.
If the handset emits a double beep, it means
that the base has reached the maximum
number of 5 subscribed handsets.

Handset Synchronization*

1. After handset is registered, wait 5-7
seconds until
RSS synchronization icon briefly appears on
the handset display. This indicates that the
handset and base are synchronized to each
other.
2. Next you will see the RSS Service Wizard
which
will guide you step by step through setup
of Weather and Weather Alerts. There are
some useful channels pre-configured to
help get you started.
-OR-
NOTE: Your handset will
automatically display the
RSS synchronization icon
for a few seconds when
the feeds are updated at
approximately 15 minute
intervals. During this
automatic process you
will not be able to search
or view your RSS feeds.
*Thomson Inc. does
not warrant that the
content of any website
or RSS feed transmitting
content to this product
(InfoLink Phone) will be
uninterrupted or error
free. Access to streaming
content through this
device is subject to
provider availability.
Thomson Inc. does not
endorse any Internet-
based content or RSS
feeds maintained by
a third party that may
be accessed using this
device.