Panasonic TH-47LFX6U Operating Instructions Manual page 13

Maintaining air fi lters
The cooling structure of the Display is designed to circulate air taken in from outside inside the Display using fans. Air
fi lters are built into the inlet and outlet.
When "Filter" is displayed on the screen as you turn on the power, or when the
power indicator is blinking green and orange alternately, there is accumulated
dust on the air fi lters. Check the condition of the air fi lter and fan in "Maintenance
Information" in the Setup menu, and clean or replace the air fi lter and inspect the
fan as necessary. (see page 42)
How to remove air fi lters
Always unplug the power plug before removing air fi lters.
1
Loosen the decorative screws on
the exhaust vent sections until
they turn freely.
2
Remove the fi lter cover, and pull
out the air fi lter.
Cleaning air fi lters
To clean the air fi lter, soak in a neutral detergent diluted 200 times with water, rinse well in water, and leave to
dry in the shade.
Notes:
• Air fi lters must be installed before using the Display. The absence of an air fi lter may cause failure in the
Display due to the intake of foreign matter or dust.
• When an air fi lter is damaged or is unobtrusively soiled even after cleaning, replace the air fi lter with a new
one. Contact your sales agent for replacement.
• The amount of foreign matter or dust adhering to air fi lters varies depending on the installation location and the
used hours. Increase the frequency of cleaning in locations where dust can easily accumulate.
• Do not remove the wire mesh below the air fi lter.
• Do not touch the fans or wiring inside the Display.
• When removing air fi lters from or installing into the Display set on a high place, take care of your own safety,
and avoid the concerned parts falling.
• Clean the air fi lters approximately once every 3 months and replace them approximately once a year.
Decorative screw
Wire mesh
Fan
• There is no fan in the inlet.
Safety Precautions
Outlet
Inlet
Air fi lter
Filter Cover
5