Identifier
Zero indicates that the device should check the supplied password against the user
password stored internally. One indicates that the device should check the given pass-
word against the master password stored internally.
The Security Erase Unit command erases all user data and disables the security mode feature (device
lock function). After completing of this command, all the user data will be initialized to zero with a write
operation. At this time, the data write is not verified with a read operation to determine if the data sector is
initialized correctly. At this time the defective sector information and the reassigned sector information for
the device are not updated. The security erase prepare command should be completed immediately prior
to the Security Erase Unit command. If the device receives a Security Erase Unit command without a prior
Security Erase Prepare command the device aborts the security erase unit command.
This command disables the security mode feature (device lock function), however, the master password is
still stored internally within the device and may be reactivated later when a new user password is set. If
you execute this command on disabling the security mode feature (device lock function), the password
sent by the host is NOT compared with the Master Password and the User Password. The device only
erases all user data.
The execution time of this command is shown below.
IC25T048ATDA05-0
IC25N030ATDA04-0
IC25N020ATDA04-0
IC25N015ATDA04-0
IC25N012ATDA04-0
IC25N010ATDA04-0
IC25N007ATDA04-0
IC25N006ATDA04-0
IC25N005ATDA04-0
52 min
38 min
24 min
20 min
16 min
14 min
10 min
8 min
8 min
Travelstar 48GH, 30GN & 15GN hard disk drive specifications
155