IBM DTTA-351010 - Deskstar 10.1 GB Hard Drive Specifications page 48

6.3.4.2 For Default Logical Head 15
I G
H
I G
H
I G
H
I G
H
Figure 32. Jumper Block Setting Position
Notes:
1. All other setting patterns are reserved. Do not make other setting.
2. When CABLE SELECT is specified, AT interface signal #28 CSEL is referred to determin the drive
address as follows:
When CSEL is grounded or at a low level, the drive address is 0 (Device0).
When CSEL is open or at a high level, the drive address is 1 (Device1).
40
O E M Specifications for DTTA-3xxxxx
E C A
F D B
E C A
F D B
E C A
F D B
E C A
F D B
D E V I C E 0 < S h i p p i n g D e f a u l t
D T T A 3 5 0 6 4 0 / 3 5 0 4 3 0
D E V I C E 1
C A B L E S E L E C T
D E V I C E 0
F o r c i n g D E V I C E 1 P R E S E N T
f o r