Pioneer DVR-LX61D Operating Instructions Manual page 147

The Initial Setup menu
Setting Options
HDMI Control On •
Off
• The KURO LINK function name used on the web and in catalogues is referred to as HDMI Control in the operating
instructions and on the product.
• For more information about HDMI Control, see HDMI Control on page 22.
• This setting is available even if you are not connected to an HDMI device.
• For more information, see Troubleshooting on page 161.
Network
IP Config. Next Screen
• If you want to set the IP address manually, Set Auto Set IP Address to Off then set the IP address, Subnet mask
and Default gateway: Use the / buttons to select the address, press ENTER, use the / buttons to select a
field; use the number buttons to enter a value. Select Set, then press ENTER.
• The IP address determined by the Auto IP function is 169.254.X.X. The functions for searching for titles in the
Gracenote database on the network and the Connect PC function with an Ethernet connection cannot be used if
the IP address is set for the Auto IP function.
• When inputting the IP address, set within the range shown below. The functions for searching for titles in the
Gracenote database on the network and the Connect PC function with an Ethernet connection cannot be used if
other IP addresses are set.
–
CLASS A: 10.0.0.1 to 10.255.255.254
–
CLASS B: 172.16.0.1 to 172.31.255.254
–
CLASS C: 192.168.0.1 to 192.168.255.254
• When an xDSL modem or terminal adapter is connected directly to the recorder, input the subnet mask indicated
in documents from your provider, etc. Normally input the following values:
–
CLASS A: 255.0.0.0
–
CLASS B: 255.255.0.0
–
CLASS C: 255.255.255.0
• For information on DHCP refer to the network device's operating instructions.
• You may need to contact your service provider or network administrator when manually entering an IP address.
• If you want to set the DNS address manually, Set Auto DNS Address Get to Off then set the DNS (Primary) and
DNS (Secondary).
• When Auto Set IP Address is set to Off, Auto DNS Address Get is also set to Off.
Explanation
Enables the HDMI Control function. Select this option when
connected to an HDMI Control-compatible Pioneer Flat
Screen TV, AV system (amplifier or AV receiver etc.) or HD AV
converter.
Disables the HDMI Control function. Select this option when
not connected to an HDMI Control-compatible component,
or when connected to a component manufactured by a
company other than Pioneer.
Set Auto Set IP Address to On. If there is a DHCP (Dynamic
Host Configuration Protocol) server on the local area network
(LAN), this recorder will automatically be allocated an IP
address. If you're using a broadband router or broadband
modem that has a DHCP server function, select On. The IP
address will automatically be determined.
If there is no DHCP server on the network and you select On,
this recorder will use its own Auto IP function to determine
the IP address.
Set Auto DNS Address Get to On. If the DHCP function can
be used with a broadband router or a broadband modem
equipped with a router function, the DNS (Domain Name
System) server address can normally be set automatically.
18
147
En