Cycle Settings; Cycle Options - Kenmore 970L8802 Series Use & Care Manual

Operating Instructions

Cycle Settings

For best results
Follow the fabric care label instructions
on items to be dried.
Appropriate drying Temperature, Dryness Level and Op-
tions will automatically be displayed for each cycle. The
settings can be changed before the cycle is started.
If changes are attempted after the cycle starts, the lights
will blink, the signal will beep and "
DRYING TEMPERATURE
To change the preset temperature, press the Temp button
to scroll to the desired setting.
To protect your fabrics, not all temperatures are available
with every cycle.
The temperature selected for the cycle will be remembered
and recalled each time that cycle is selected in the future. To
return to factory settings, press the START/PAUSE and Select
buttons at the same time and hold until the signal sounds.
NOTE
To change the temperature after the cycle starts, press
PAUSE, adjust the setting and press START to resume the
cycle.
Max
Recommended for durable fabrics and towels.
High
Recommended for most cotton fabrics.
Medium
Recommended for wrinkle free, easy care, lightweight
fabrics and bulky loads.
Low
Recommended for delicate fabrics.
Air Fluff
This setting (no heat) should only be used with a Timed Dry
cycle to dry items containing feathers, down, foam rubber,
plastics or rubber-like materials; to refresh clothing, stuff ed
animal, pillows or blankets; and to dust draperies.
Err
" will be displayed.
8
DRY LEVEL (Auto Dry)
To change the preset level, press the Dry Level button to
scroll to the degree of dryness desired.
To protect your fabrics, not all dryness levels are available
with every cycle. If a Dry Level is not appropriate for the
cycle, it cannot be selected.
NOTE
To change the Dry Level after the cycle starts, press
PAUSE, adjust the setting and press START to resume the
cycle.
Select the Normal dry level for most Auto Dry cycles.
Occasionally a load may seem too damp or over-dried
at the end of the cycle. To increase drying time for similar
loads in the future, select a higher setting. For loads requir-
ing less drying time, select a lower setting.
Select Damp for items you wish to partially dry before
hanging or ironing.

Cycle Options

To select an option, press Options until the indicator for the
desired option fl ashes, then press Select. If an option is not
available for a cycle, the indicator will not light. Follow the
same steps to delete an option.
Chime
A signal will sound at the end of the cycle if this option
is selected.
Wrinkle Guard
Select Wrinkle Guard if the dried load might not be
removed promptly at the end of the cycle. The dry
load will continue tumbling without heat to help reduce
wrinkling. When Chime is selected, a beep will be heard
periodically. The load may be removed any time during
Wrinkle Guard.