Table of Contents
Advertisement
Replenishing the Toner (418-0 Printpowder
Replacing the Toner Bottle (To reorder 418-0 Printpowder, call 1-800-462-6797)
1
Open the Toner Bottle Cover and gently pull
out the used Bottle.
If the Toner Bottle Cover is opened while the
Bottle is turning, the Bottle may be locked in
place, If this happens, close the Cover, wait for
the Bottle to stop, and try again.
2
Sharply tap the new Toner Bottle against a
desk or other hard surface four to five times.
Then turn the Toner Bottle upside down and
tap it the same way again.
3
Shake the new Toner Bottle well and turn it
over lengthwise five times.
Make sure to carry out the procedure above to
agitate the toner well before installing the toner
bottle in case the toner has settled.
4
With the Seal on the Toner Bottle facing up,
slowly peel off the Seal as illustrated.
Be careful, some toner may puff out from
the bottle.
5
With the "UP" marking on top, insert and
push the Bottle into position. Close the Toner
Bottle Cover.
Push the Bottle up to the black line on it.
16
1166O093AB
1166O228AA
1166O095AA
1139O1390A
1166O219AA
Advertisement
Table of Contents
